Troubleshooting - TRENDnet TEW-653AP Guide D'installation Rapide

Troubleshooting

How do I configure TCP/IP settings on my computer?
Windows Vista
1. Go into the Control Panel, click Network and
Internet, click Network and Sharing Center,
click Manage Network Connections and then
right-click the Local Area Connection icon and
then click Properties.
Windows XP/2000
1. Go into the Control Panel, double-click the
Network Connections icon and then right-click
the Local Area Connection icon and then click
Properties.
I typed http://192.168.10.100 in my Internet Browser's Address Bar, but an error message
says "The page cannot be displayed." How can I get into the TEW-653AP's web
configuration page?
1. Check your hardware settings again by following the instructions in section 2
2. Make sure the wireless, LAN and power LEDs are lit.
3. Make sure the TCP/IP settings are configured properly (see first question).
4. Since the Access Point's default IP address is 192.168.10.100, make sure that no
other network devices are assigned an IP address of 192.168.10.100.
5. Reset the TEW-653AP. Take a pin or paper clip and press the reset button for 15
seconds. The reset button is located on top of the TEW-653AP.
2. Click Internet Protocol Version 4(TCP/IPv4)
and then click Properties. Then click on Use
the following IP address, and make sure you
assign your network adapter an IP address in
the subnet of 192.168.10.x.
2. Click Internet Protocol (TCP/IP) and then click
Properties. Then click on Use the following
IP address, and make sure you assign your
network adapter an IP address in the subnet of
192.168.10.x.
9