Teckentrup car Teck 12.1 Notice De Montage Et D'utilisation page 31

1
2
3
4
5
6
Attention: After programming these functions please re-programme
the travel path and power again.
Attention: Any mistakes pressing the buttons can only be deleted by
switching off and pulling out the 230 V plug. Then repeat
the procedure as outlined again.
Subject to technical modifications without prior notice.
Press TL 5 sec. until yellow LED lights permanently.
Press TL again 5 sec. until red LED lights permanently.
Press again TL 2 times briefly, red and yellow LEDs begins to flash.
Press TS 1 sec., red and yellow LEDs begins to flash.
Programme soft start/stop long
Press TL, red and yellow LED go off.
Programme very long soft start in direction closing:
Press TL 5 sec. until red and yellow LEDs go off.
Follow steps 1 - 6 except for 4.
Return to standard soft start/stop:
Press TS, red and yellow LEDs turn off.
Follow steps 1 - 6 except for 4 and 5.
programming soft start/stop long 31
TP-12. 1 -07/13