Front Panel - Accuphase E-213 Mode D'emploi

Playback With an External Preamplifier
You can set the EXT PRE selector to ON to separate the preamplifier and power amplifier of the E-213, and use an external preamplifier
or A/V amplifier with the power amplifier of the E-213. An example of such a connection is shown below.
RCAUTION:
m Connect the output of the external preamplifier to the POWER IN jacks of the E-213.
m Only the power amplifier of the E-213 is used in this case. The preamplifier is inactive. Input source
switching, volume adjustment, and other preamplifier functions must be performed at the external equipment.
NOTE:
Source component
Be sure to turn power to all components off before making
connections.
If you set the EXT PRE selector to OFF,
the E-213 will operate normally (using
the internal preamplifier).

Front panel

Set EXT PRE selector to
.
ON
External preamplifier,
A/V amplifier, etc.
Left speaker
To POWER IN jacks
Audio cable with
RCA-type plugs
Preamplifier output
Right speaker
9