Introduction; Parts List - Lippert Components Duraself Flow Max Manuel D'installation Et D'utilisation

Introduction

The Flow Max Fluid Pump by Duraself (Model Number:
™
DS-01233-D) delivers smooth, consistent flows at all
ranges of operation while drawing low current. The motor
design incorporates ball bearings for long life and the
motor is equipped with an integral thermal breaker. The
RV/marine duty pump has sealed switches and is finished
with electrocoating to inhibit corrosion. The pump is also
enclosed to prevent incidental moisture from entering.
The Flow Max Fluid Pump is capable of self-priming up
to 6 vertical feet and can run dry. The pump is designed
for intermittent duty only. Do not use the pump for running
a Reverse-Osmosis (RO) Filtration System. Continuous
running under higher pressure may reduce pump life.
There are no replaceable parts for the pump.
For safety, it is recommended that power to the pump is
shut off when leaving the unit unattended.
THE "WARNING" SYMBOL ABOVE IS A SIGN THAT
AN INSTALLATION PROCEDURE HAS A SAFETY RISK
INVOLVED AND MAY CAUSE DEATH OR SERIOUS
INJURY IF NOT PERFORMED SAFELY AND WITHIN THE
PARAMETERS SET FORTH IN THIS MANUAL. ALWAYS
WEAR EYE PROTECTION WHEN PERFORMING
THIS INSTALLATION PROCEDURE. OTHER SAFETY
EQUIPMENT TO CONSIDER WOULD BE HEARING
PROTECTION, GLOVES, AND POSSIBLY A FULL
FACE SHIELD, DEPENDING ON THE NATURE OF THE
INSTALLATION PROCEDURE.
MOVING PARTS CAN PINCH, CRUSH OR CUT. KEEP
CLEAR AND USE CAUTION.
lippertcomponents.com 574-537-8900
Flow Max
Fluid Pump
Installation and Owner's Manual
(For Aftermarket Application)

Parts List

B
Letter Description
A Flow Max Fluid Pump LCI PN
B Screen Filter and Connectors LCI PN 689059
2
Rev: 11.17 - Flow Max
12V DC
™
by Duraself
A
689052
12V DC Fluid Pump
™
Qty
1
2