Glacier bay VWD1066BLS Guide D'utilisation Et D'entretien page 7

Pre-Operation (continued)
INSTALLING THE WATER BOTTLE
iMPOrTanT: Always wash your hands prior to installing the
water bottle! Clean the top of the water bottle with a clean cloth.
Water bottles can be purchased from your local retailer.
□ Make sure the lower door (I) (bottle storage compartment) is
open. The water pump can not operate as long as the door is
in the open position.
□ Remove the protective label from the top of the bottle.
□ Most water bottles have a puncturable membrane in the top cap.
To puncture the membrane, insert the stainless steel straw (K)
into the cap and push downward until the membrane opens.
□ Insert the straw all the way into the bottle until the bottom
of the straw touches the bottom of the water bottle.
nOTe: The water bottle drinking straw features an exclusive telescopic design for use with either 5 gallon or 3 gallon water bottles. To adjust the
length of the water bottle drinking straw, hold the upper portion of the straw and simply pull/push the lower portion of the straw to the desired length.
□ To attach the water bottle straw onto the neck of the water bottle, press firmly onto the top of the bottle neck.
iMPOrTanT: Do not break or remove the seal from around the neck of the water bottle
□ To install the water bottle inside the bottle storage compartment, simply position the bottle in front of the storage comportment ramp,
and slide it inside using the side of your leg until the bottle comes to a stop.
□ Close the lower compartment door (I), and the water pump will start delivering water into the dispenser automatically. When the
internal reservoirs are full, the water pump will stop automatically.
iMPOrTanT: Your Glacier Bay water dispenser is designed with a special "safety" feature (low water level sensor) that controls activation/
operation of the kettle feature hot water tank heating system. If no water is present and/or low water levels are detected inside the internal
water reservoir, activation/operation of the kettle feature hot water heating system is not possible. Likewise, if the hot water heating system is
operational and water is being drawn simultaneously causing internal water levels to drop below the established minimal level set point, hot
water tank operation is automatically suspended. To reactivate the hot water heating system, you must replenish your water supply. Operation
of the cold water system is not affected by this safety feature.
DRINKING STRAW INSTRUcTIONS
The drinking straw lower section incorporates 3 indents
and a locking clip to prevent retraction of the straw when
inserted into the water bottle. Depending on the size of
the water bottle being used, simply snap the locking clip
onto the corresponding indent.
I
5gal Bottle
Locking Clip Indent
4gal Bottle
Locking Clip Indent
3gal Bottle
Locking Clip Indent
7
Please contact 1-877-527-0313 for further assistance.
K
WATER
BOTTLE
Straw Cap
Straw Upper Section
Locking Clip
Straw Lower Section
HOMEDEPOT.COM