Lanmodo 40466 Mode D'emploi page 3

3. Install Lanmodo Car Tent On Car
1.Take out Lanmodo car tent from package;
2. Install the car tent base at the center roof of your vehicle, please make sure the car roof surface is clean and
smooth to put suction and ensure car tent handle with security strap is facing you;
3. Untie the gathering rope;
4. Pull the suction handle down to activate the suction, please make sure the suction is stable;
5. Trap the security strap inside the door of the vehicle;
6. Deploy the canopy by pressing "Open" button on wireless remote controller (Please stop instantly by
pressing "Open" button if the canopy is obstructed, and then operate open or close process);
7. Locate all the windproof ropes.
4. Product Specification
Motor
Rated Motor Power
Working Currency
Maximum Power
Battery
Capacity
Full Charge by Car Charger
Full Charge by Wall Charger
USB Output
Structure
Fiberglass tensile strength
Connector
Canopy
Water Pressure
Brush Motor
10W
1A
1000N.M
18650 Lithium Battery
2200mAh
5 Hours
3 Hours
5 V
Fiberglass & Metal
6.3 ~ 6.9 g/d
Plastic
210D Oxford cloth
350Mpa