Setting Codes; Delete Code - Siemens Codoor CD3500 Manuel D'installation Et De L'utilisateur

CD3500 & CD4000 Installation and User manual

Setting codes

With Codoor you can program up to 9 different codes (codes 01-09).
Follow these steps:
1. Press  then enter the 6-digit
programming code. Finish by
pressing . The red LED will flash
slowly, accompanied by simultaneous sounding of the buzzer.
2. Press  then enter the code number (01-09) you
want to program. Finish by pressing . The red
LED will flash faster.
3. Press  then enter the desired 4-digit
code. Finish by pressing . The green LED
will come on for 2 seconds. To enter any
additional codes, repeat steps 3 and 4.
4. Exit programming mode by entering  00 . The
buzzer sounds a rising tone to confirm.
Note! The unit automatically switches out of programming mode
into operating mode if no key is pressed within 10 seconds.
Programming must be done while the red LED flashes and
the buzzer sounds.

Delete code

Proceed like this:
1. Press  then enter the 6-digit
programming code. Finish by
pressing . The red LED will flash
slowly, accompanied by simultaneous
sounding of the buzzer.
2. Press #, then enter the code (01 - 09) you wish
to delete. Finish by pressing #. The green LED will
come on. If you wish to delete more than one code, repeat step 3
for each code.
3. Exit programming mode by entering  00 . The
buzzer sounds a rising tone to confirm.
 
 
 
0 0
 
 
# #
0 0
 
11
 
 
 
0 0
 
 
# #
0 0
 