weltico TUNABLE white Notice D'utilisation page 6

EN
1. TECHNICAL CHARACTERISTICS LED PAR56 LAMP TUNABLE
Tunable COLOR
10 colors / 5 sequences of linked colors
Change of colors or sequences (standard) by switching off the
power switch «on / off»
Change colors or sequences with a kit (optional): on / oFF remote
control or multifunction module.
Keep in memory after switching off the bulb the color or the
predefined sequence.
2. RECOMMENDATION
this leD par56 lamp is compatible with most type par56 submerged pool projectors.
turn off the power supply to projectors and replace the bulb following the instructions in the projector's usage notice.
Consider changing the watertight seal between the bulb and its support for a new seal then installing the
the original bulb. If you do not replace the watertight seal this may lead to water seeping in between the lamp and its support, and consequently
damage to the bulb.
par56 tunable
If the bulb's power is supplied by an electronic transformer there is a risk it may not work (contact your retailer for details).
If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by the manufacturer, its service agent or similarly
qualified person, in order to avoid all risks.
provide a power supply 10% higher than the power absorbed by the bulb. For example: a power supply of 300 watts provides power for 9 bulbs
64192lb30. 7 x 36 = 252 W. the voltage drops can be very strong on bad connections, lugs and son loose oxidized. measure the voltage at the
end of the cable without the bulb. minimum required voltage: 10.5 V. maximum supported voltage: 13.5V.
12 leds tunable white
Cable section
2 x 1,5 mm2
2 x 2,5 mm2
2 x 4 mm2
2 x 6 mm2
2 x 10 mm2
For optimum light in your pool, always keep the bulb as below:
ampoule par56 tunable - 01/2021
20 W
Distance max box/
projector
14 ml
24 ml
38 ml
57 ml
94 ml
9 programs that allow you to vary from warm white to cool white.
Change of blank sequences (standard) by switching off the power
Changing white sequences using the kit (optional) receiver
Controller-modulator with wireless remote control.
Keeps in memory after switching off the bulb the predefined blank
Attention
12 leds tunable Color
Cable section
2 x 1,5 mm2
2 x 2,5 mm2
2 x 4 mm2
2 x 6 mm2
2 x 10 mm2
6 en
Tunable WHITE
switch «on / off»
sequence.
par56 tunable
36 W
Distance max box /
projector
8 ml
13 ml
21 ml
31 ml
52 ml
bulb in place of