Bluetooth Pairing; Automatic Pairing - König HAV-SB500 Manuel De L'utilisateur

Installation (fig. B & C)
• Refer to the illustrations to install the device
correctly.

Bluetooth pairing

Automatic pairing

1. Switch on the soundbar.
2. Connect the Bluetooth device.
Note: Make sure that your Bluetooth device is
the last connected device.
3. Switch on the Bluetooth device.
4. Set the source to Bluetooth. The Bluetooth
device will be paired with the soundbar. The
Bluetooth indicator lights continuously.
Manual pairing
1. Switch on the soundbar.
2. Set the source to Bluetooth.
3. When the Bluetooth indicator flashes, the
soundbar is in pairing mode.
4. Connect the Bluetooth device.
5. Switch on the Bluetooth device. The
Bluetooth device will search for the Bluetooth
ID of the soundbar: "HAV-SB500".
6. If the password window shows, enter the
password: "0000". The Bluetooth device will
be paired with the soundbar. The Bluetooth
indicator lights continuously.
NOTE: Remove connector protection caps from
bundled optical and HDMI™ cable before usage
Safety
General safety
• Read the manual carefully before use. Keep the
manual for future reference.
• Only use the device for its intended purposes.
Do not use the device for other purposes than
described in the manual.
• Do not use the device if any part is damaged or
defective. If the device is damaged or defective,
replace the device immediately.
• Do not expose the device to water or moisture.
• Do not block the ventilation openings.
Electrical safety
• To reduce risk of electric shock, this product
should only be opened by an authorized
technician when service is required.
• Disconnect the product from the mains and
other equipment if a problem should occur.
Battery safety
• Use only the batteries mentioned in the manual.
• Do not use old and new batteries together.
• Do not use batteries of different types or brands.
• Do not install batteries in reverse polarity.
• Do not short-circuit or disassemble the
batteries.
• Do not expose the batteries to water.
• Do not expose the batteries to fire or excessive
heat.
• Batteries are prone to leakage when fully
discharged. To avoid damage to the product,
remove the batteries when leaving the product
unattended for longer periods of time.
• If liquid from the batteries comes into contact
with skin or clothing, immediately rinse with
fresh water.
5 5
English