Care & Maintenance; Auto Defrost - Danby DDR050BCWDB-ME-6 Manuel Du Propriétaire

CARE & MAINTENANCE
ERROR CODES
If the display panel shows any of the below error
codes, unplug the dehumidifi er, let it stand for
5-10 minutes and then plug it back in. If the error
persists, call for service.
EH60 - room temperature sensor error
EH61 - evaporator sensor error
EH0b - display board or master control board
communication error
P2 - bucket is full
Eb - bucket is not installed
POWER FAILURE
In the event of a power failure or if the appliance
is unplugged, it will resume normal functioning
when power is restored. The mode and fan speed
will resume at the settings chosen before the power
failure.

AUTO DEFROST

When frost builds up on the evaporator coils, the
compressor will cycle off and the fan will continue to
run until the frost melts. The dehumidifi er may emit
the sound of running water. This is the refrigerant
moving through the coils and is normal.
END OF SEASON CARE
Unplug the dehumidifi er and ensure the fi lter is
clean. Ensure the bucket is empty and then allow
both the bucket and the dehumidifi er to dry
completely before storing for the off season.
It could take a few days for water inside the
dehumidifi er to completely evaporate. Wipe the
bucket with a dry cloth and ensure the drain has
been emptied to speed up this process Store the
dehumidifi er covered in a dry location.
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling of
electrical components. Check for local regulatory
compliance regarding approved and safe disposal
of this appliance.
11