Remote Control - Kimex 160-1010T Manuel D'utilisation

REMOTE CONTROL

Battery installation
• Remove the battery cover on the back of the remote control
and insert two AAA (1.5V) batteries. Make sure that the polarity
matches the + and - marks on the battery compartment of the
remote control.
•
Do not use different types of batteries. Never mix new and old
batteries. Always replace batteries in pairs.
• Do not burn, charge or disassemble batteries.
Never dispose of used batteries with household waste but in the
recycling bins provided for this purpose, e.g. in your
supermarkets or in accordance with local environmental
regulations.
Precautions for using the remote control
• Aim at the infrared receiver located below the right corner of
the screen. Do not place any objects between the remote
control and the receiver to avoid interference and to ensure
normal operation.
• Keep the remote control away from strong vibrations. Do not
place the remote control under direct sunlight or on a radiator,
as this may deform and damage it.
• The remote control signal may not work if the infrared receiver
is exposed to sunlight or strong lighting. In this case, adjust the
angle of the lighting on the device or move closer to the
receiver.
•
The maximum operating distance of the remote control is 5 m,
which can be shortened if the battery charge is insufficient, in
which case replace the batteries with new ones. If the remote
control is not used for a long period of time, remove the
batteries to prevent corrosion that could damage the remote
control.
Page 23 de 24