Safety Regulations - LEM UNILAP GEO X Manuel D'utilisation

1.

Safety Regulations

This measuring device is only designed for the use on system parts
which normally do not carry dangerous voltages.
This measuring device is only to be installed and operated by qualified
personnel and according to the technical data in compliance with the
safety precautions and regulations set forth below. Additionally, the use
of this equipment requires compliance with all legal and safety
regulations pertaining to each specific application. Similar regulations
apply to the use of accessories.
Operating electrical devices implies that parts of the device carry
dangerous voltages. Disregarding warning notices may lead to
serious physical injury and material damage.
Fault-free and safe operation of this device requires suitable transport and storage,
setting up and assembly as well as careful operation and maintenance.
If there is reason to believe that safe operation is no longer possible, the device has to
be put out of operation immediately and must be protected against accidental
restarting.
It can be assumed that safe operation is no longer possible if the device
•
shows visible damage,
•
has been exposed to unfavourable conditions (e.g. storage beyond the
permissable climatic limits, dewing etc.) or
•
has been exposed to major strain during transport (e.g. been dropped from some
No measurements must be performed on unprotected measuring
circuits.
Adapter for stakeless ground testing
A640311 GA1 Z REV 1
height without visible external damage etc.).
Safety Regulations
7