VONROC GP525AC Traduction De La Notice Originale page 9

Switching on/off (Fig. A)
1. Check that the ON/OFF switch (1) is in the 'O'
position before connecting the pump to the
power supply.
2. Move the ON/OFF switch (1) into the position
'I' to switch the pump on. When you start the
pump, there will be a lot of air in the water first.
This is not a defect of your pump, but serves to
remove air from the pump. It may take several
minutes for the air to escape when the pump is
immersed for the first time.
3. Move the ON/OFF switch (1) into the position 'O'
to switch the pump off.
Finish operation (Fig. A, G)
Do not touch the pump unless its power has
been cut off for at least 5 minutes.
When there is the risk of frost or if you do
not use your pump for a long time, please
properly store your pump.
1. Check that the ON/OFF switch (1) is in the 'O'
position.
2. Remove the mains plug from the mains.
3. Unscrew and remove the drain plug (2). Let the
water drain.
4. Pull up the suction hose (be aware, it is full of
water).
5. Unscrew the suction hose (8) from the water
inlet (3).
6. Remove the filter and foot valve (4), then rinse
with clear water. Make sure that there is no
water left in the suction hose (8).
7. Remove the water hose from the water outlet (6).
Unscrew the coupling from the water outlet (6).
8. Place the drain plug (2) back, do not overtighten.
9. Clean and store the device (see 'Maintenance')
WWW.VONROC.COM
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Remove very
persistent dirt using a soft cloth moistened with
soapsuds. Do not use any solvents such as gasoli-
ne, alcohol, ammonia, etc. Chemicals such as these
will damage the synthetic components.
If the appliance appears to be blocked, switch off
the power at the mains, remove the plug from the
socket and check the appliance for blockages.
Clean suction hose, foot valve, pre-filter and pump.
STORAGE AND FROST POTECTION
The garden pump and accessories that are not
completely drained can be destroyed by frost.
Completely drain the garden pump and accessories
and protect them against frost.
Keep this appliance in well-ventilated dry premises
with temperature not going below +5°C.
When not in use, keep this appliance stored in a
safe place out of reach of children.
TROUBLE SHOOTING GUIDE
Problem Cause
Pump does not No mains supply
start
Pump is active The pump is not
but no water is fully filled with
being delivered water
(after being star-
ted for more than
5 minutes) Air in the suction
hose
Water level is too
low
Suction hose, foot
valve, pre-filter or
pump is blocked
EN
Remedy
Check mains supply
Re-fill the pump
with water and
check the suction
hose foot valve
Check sealing of
various joints of the
suction hose
Adjust installation
height of the pump
(< 8 m)
Clean suction hose,
foot valve, pre-filter
or pump
9