Fell Marine MOB+ xHUB BU90115 Manuel Utilisateur page 20

1.
2.
3.
4.
5.
WARNING
20
Connecting the Power
(10 – 32Vdc)
Use a test light or a voltmeter to determine
the polarity of the voltage source.
Connect the red (+ or positive) wire to the
positive voltage terminal. (If you use the
fuse block on the boat, route the positive
connection through the fuse, as shown on the
diagram.)
Connect the black (- or ground) wire to the
negative voltage terminal.
Install or check the 1 A - 3 A fuse (in the
in-line fuse holder, or on the fuse block of
the boat.
Use wire hoods suitable for the wire
dimension (20AWG, 0.75mm2) or connection
point on the fuse block.
Connect the leads to a stable power source that
is not susceptible to voltage drops.