ARIETE 2706 Mode D'emploi page 17

troubleshooting
Warning!
Immediately switch off the appliance in case of operational faults and electrical failures. Unplug it from the socket-
outlet. Wait for the appliance to cool down.
PROBLEM
On light off
No steam comes out of
the nozzle
Unexpected increase
of the noise level of the
pump
Water leakage from the
nozzle
CAUSE
Not plugged in
Steam dispensing button not
pressed
The appliance is not ready
for use
Water shortage in tank
Incorrect insertion of the tank
in its seat
The steam exit holes may be
blocked by limescale
Water shortage in tank
Incorrect insertion of the
tank in its seat
Possible condensation
residue in the steam duct
REMEDY
Check that the appliance is properly plugged in. Check that
there is current on the power supply line. Try to plug the
appliance into another socket-outlet. If the problem continues,
contact an Authorised Service Centre.
Press the steam dispensing button all the way down.
Press the steam dispensing button for thirty (30) seconds or
until you hear the noise of the pump. Wait for the steam to
come out.
Fill the tank up to the level marked MAX.
Remove the tank and put it back in, making sure it is in the
right position.
Contact an Authorised Service Centre.
Turn off the appliance and fill the water tank.
Remove the tank and put it back in, making sure it is in the
right position.
Press the steam dispensing button until you see steam
coming out. Position a soft cloth so as to not dampen the
floor. If water continues to come out, turn off the appliance.
Wait at least 5 minutes so that the steam head and cloth cool
down. Try again.
15