Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 4 fitting brackets
- 2 nettings 190 mm x 80 mm
- 4 plastic washers Ø5
- 1 piece of double-sided tape L=200mm
Central part
Fitting instructions
- Aluminium nettings are optional and can be fitted at the air intake level with silicone.
- Place the fitting brackets as shown on the pictures below, without tightening so as to adjust the belly pan position.
- Remove the silent block metallic part. Insert the rubber part into the fitting holes of the belly pan. And then fit
again the metallic part, with the flange on the outside.
- Assemble the belly pan with the central part thanks to the double-sided tape. Provided screws 5x15 are going on
the lower part.
- Place and screw the belly pan with the provided screws 6x20. Adjust the belly pan position by moving the
brackets if necessary. Then tighten the screws.
- Once fitted, the belly pan must have no contact with engine and has to be far enough from complet exhaust
system. Fitting brackets' angles may be a little modified in order to adjust the accessory to every motorbike
(do not fold the fixing brackets while fitted on belly pan).
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
- 4 screws BHC 6x20 black big head
- 4 screws BHC 5x15 steel
- 4 nuts Ø5
Ø6 fastener location
Fitting bracket with
the fastener Ø6
« CAUTION »
FITTING INSTRUCTIONS
ERMAX EVO BELLY PAN ADAPTABLE ON
YAMAHA MT 09 / FZ9 2014 → ∞
YAMAHA MT 09 / FJ9 TRACER 2015 → ∞
YAMAHA XSR 900 2016 → ∞
- 1 fastener Ø6
- 4 silents block
- 1 central part
Estimated fitting time : 30 min
Cut and adjust the
netting so that it does
not straddle the
central part
Publicité
