Status Messages/Error Messages - Zoef Robot BERTA MR18Z Manuel De L'utilisateur

Status messages/error messages

Emergency off actuated
E 1
Re-start the robot
Lifting sensor triggered
E2
Rear wheel blocked or lifted? Restore
the rear wheel then re-start the robot.
Robot outside of the boundary line
E3
primeter.
Place robot inside, restart
Boundary line cut
E4
Red indicator LED flashes? Repair
boundary line, restart robot
Collision sensor triggered
E5
nder
Obstacles? Re-start the robot
s
t
Overcurrent on the left drive-motor.
E6
Grass too high? ( > 4cm)? Left wheel
blocked? Re-start the robot
Overcurrent on the right drive-motor.
E7
Grass too high? ( > 4cm)? Right wheel
blocked? Re-start the robot
Overcurrent at the cutting motor
E8
Grass too high? ( > 4cm)? Cutting sleeve
blocked? Re-start the robot
Error charging status
E9
Malfunction of the battery. Re-start
the robot multiple times, if the issues persisits,
contact service.
Over-/undercurrent of the robot.
E 10
Malfunction on the PCB bodard. Restart
the robot multiple times, if the issues persists,
contact service.
Tilting sensor tripped
E 11
Inclination in excess of 20 degrees? Re-
start the robot
Wheel slipping
E 12
Grass too high or too wet? Re-start the
robot.
Overheating on battery
E 13
Wait for the battery to cool down.
Re-start the robot.
Robot does not start, signal
F 1
present
Robot is started outside of the boundary line or too far
from it? Restart the robot.
Robot does not start, no signal
F2
(charging station)
Boundary line/mains adapter correctly
connected?
Robot does not start
F3
The power of robot mower is turned off previously?
-
Bring it onto the charging station and restart it.
Battery voltage too low
F4
Completely charge the robot
Re-start the robot
1.
Place the robot on the boundary line
2. Enter the safety code
3.
Push the start button
If the robot is turned off previously, it can only be
started on the charging station.
User Manual
EN
| 21 |