Machine Information; Technical Specifications - VONROC ET502AC Traduction De La Notice Originale

EN
the fastener causing an injury.
• Do not actuate the tool unless the tool is placed
firmly against the workpiece. If the tool is not in
contact with the workpiece, the fastener may
be deflected away from your target.
• Disconnect the tool from the power source
when the fastener jams in the tool. While
removing a jammed fastener, the tacker may be
accidentally activated if it is plugged in.
• Use caution while removing a jammed fastener.
The mechanism may be under compression and
the fastener may be forcefully discharged while
attempting to free a jammed condition.
• Do not use this tacker for fastening electrical
cables. It is not designed for electric cable
installation and may damage the insulation of
electric cables thereby causing electric shock
or fire hazards.
Before using the tacker
• Check the following points:
• Do the voltage of the engine and the engine
safe-guard, if any, correspond to the mains
voltage (appliances for a mains voltage of
220-240 V);
• Are the mains lead and the mains plug in
a good condition: solid, without any loose
ends or damage.
• Always wear eye protection when using the tool.
• Maintain the tool with care.
• Check for misalignment or binding of moving
parts, breakage of parts, and any other con-
dition that may affect the tools operation. If
damaged, have the tool serviced before using.
• Check if the slide cartridge has been fastened
properly.
• Do not use the tool in a humid environment.
• Do not use the tool on materials containing
asbestos.
• Secure the workpiece firmly. Use clamps or a
vice to firmly hold the workpiece. This results in
a safer grip than with your hand.
• Always ensure that the cable is behind the
device.
Using the tool
• Do not use the tool if the switch does not move
in "Lock" or "Unlock" position.
• Always hold the tool with two hands while starting.
• Always keep the cord away from the moving
parts of the machine.
6
• Keep your hands away from the work piece.
• In the case of jamming by a nail or staple,
switch the machine immediately in lock position
and remove the plug from the mains.
• Never aim the tool at people or animals.
• Use only staples or nails fit for this tool.
• Make sure not to damage any leads when using
the tool.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate label.
Class II machine - Double insulation - You
don't need any earthed plug.
Remove all staples/nails from the magazine
after each use

2. MACHINE INFORMATION

Intended use
The tacker enables you to fasten various materi-
als, such as fabric, wood, gauze, cardboard and
leather. Therefore, the tool is suitable to upholster
furniture, to wrap objects or to repair shoes.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Number of staples/nails
Staples
Nails
Weight
Sound pressure level L
PA
Acoustic power level L
WA
Vibration
ET502AC
220-240V~
50 Hz
30/min.
6 up to 14 mm
15 mm
ca. 0.65 kg
73.8+3 dB(A)
84.8+3 dB(A)
4.678+1.5 m/s
2
WWW.VONROC.COM