Connection Diagrams - Denon DJ SC5000 Prime Guide D'utilisation

Setup
1. Make sure all of your devices are powered off or all of their volume levels are at their minimum positions.
2. Connect SC5000 Prime's audio outputs (Layer A/B or Digital Outputs A/B) to the inputs of your mixer.
3. Connect SC5000 Prime's Link ports according to one of the following connection diagram examples.
4. Connect any output devices (turntables, headphones, power amplifiers, loudspeakers, etc.) to the outputs of
your mixer.
5. Connect all of your devices to power sources.
When starting a session, power on (1) SC5000 Prime and other input sources, (2) your mixer, and then (3)
output devices.
When ending a session, power off (1) output devices, (2) your mixer, and then (3) SC5000 Prime and other
input sources.

Connection Diagrams

Items shown but not listed under
Example 1
This example shows 2 SC5000 Prime units with their Link ports connected to each other directly.
SC5000 Prime
(rear panel)
Power outlet
USB drive
4
Introduction > Box Contents
X1800 Prime mixer
(rear panel)
SD card
are sold separately.
Power outlet
SC5000 Prime
(front panel)
USB drive
SC5000 Prime
(rear panel)