Safety Information - Schildkröt Trottinette de ville STREET MASTER 510001 Manuel Utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
Please read this user manual to ensure optimal and safe use of the product.
Product and user manual are conform to standard DIN EN 14169 (Class A).
Assembly by adults only.
This product is intended for private use only. It is not suitable for commercial use.
Specifications
Article:
Schildkröt City Scooter STREET MASTER
Article number:
510001, 510002
Dimensions:
Length 96 cm, Height max. 100 cm, Footboard 37,5 x 13 cm
Weight:
4,5 kg
Maximum user weight:
100kg
Read and follow the user manual and any other information before assembling and using the product. Failure to observe can
cause serious or even fatal injuries. The user manual is an integral part of the product. When giving the product to third parties, please make
sure to hand over this user manual as well.
For the safety of your children, it is your responsibility to read these information together with your child to ensure your child understands all
warnings, safety information, and user instructions. We strongly recommend checking the scooter's condition and the knowledge of your
child from time to time and to frequently review all warnings and safety information with your child.
Supervise children during use and never let them ride alone in traffic!

Safety information

-
Observe all applicable traffic rules and regulations regarding the use of scooters in your country.
-
Only one person may use this scooter at any given time.
-
Use this scooter on suitable grounds that are flat, clean, dry, and ideally without the presence of other road users.
Wet slippery and uneven surfaces may affect the traction of the wheels, thereby causing accidents and falls. Do not ride through mud,
water or puddles. Do not ride on roads covered with ice or snow.
-
For your own safety always wear suitable protective clothing.
Never ride without helmet, hand and wrist protection, elbow protection, and knee protection.
-
Before starting: Check all connectors or fasteners for integrity and stability (e.g. the folding mechanism and the correct height of the
handlebar).
-
Make sure the kickstand (if existent) is always folded when riding.
-
Avoid sloping terrain or steep grounds.
-
Always wear suitable shoes (never ride without shoes or with sandals or shoes that do not allow for firm, secure stance).
-
Do not ride during darkness and/or under conditions of poor visibility.
-
Always be aware of pedestrians and other road users. Always show consideration for others.
-
This scooter is not suitable for performing jumps or stunts.
Installation
-
The scooter is folded during transportation. (fig. 1)
-
Open the quick-release skewer located on the right front above the footboard by pulling the lever, causing the transport safety lock to
disengage (fig. 2).
-
Then press the lever at the center of the folding mechanism and fold the steering rod towards the front until the quick-release skewer
clicks into its intended groove at the front (fig. 3).
-
Lock the quick-release skewer on the right (fig. 4). If not tight enough, open the fastener again and tighten the opposite nut for the
complete quick-release skewer to sit more tightly on the folding mechanism. Repeat these steps until the folding mechanism is fixed
without play.
-
Open the larger quick-release skewer located on the head of the steering rod (T section) by folding the locking bracket upwards
(fig. 5).
-
Release the grips from the sockets located on the side of the handlebar shaft. Insert both ends into the head (T section) and use your
thumb to press down both knobs until the end pieces of the handlebar can be inserted smoothly. A groove on the bottom of the ends
of the handlebar and inside the T section indicates the right position. The knobs must click into their respective holes (fig. 6).
-
Close the quick-release skewer by firmly pressing down the locking bracket (fig. 7).
-
Adjusting the height of the steering rod:Loosen the quick-release skewer on the top of the handlebar shaft by pressing the lever away
from the shaft (fig. 8).
-
The height of the handlebar can be adjusted to 4 different positions. To do so, pull the steering rod off the shaft until the desired height
is reached and the locking knob clicks into its respective hole (fig. 9).
Thank you for choosing this SCHILDKRÖT scooter.
5
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Trottinette de ville street master 51002

Table des Matières