Use - Casselin CRE Mode D'emploi

ELECTRICAL HAZARD
Risk from electrical current!
In case of improper installation, the device can be dangerous and cause injury. Before installation, check the
power system data. Connect the device only when there is compliance. The unit should be unpacked and
checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
• Do not touch with bare hands the surfaces of the electric stove and utensils
MANUAL
COMMISSIONING
The unit must be completely removed from its packaging. All guards must be fully
withdrawn.
Place the machine upright on a solid, flat surface. Never put the unit on a flammable surface.
Do not install this device near open fires or other heating appliances.
It is prohibited to place on the device or in the distance less than 10 cm of the device flammable objects.
Before first use, clean the device with the soft, damp cloth. Do not use detergents or aggressive aerosols.
USE
Plugging in, the indicator lights up red.
Adjust the stove with the thermostat knob to the desired temperature. The setpoint temperature is between
... and .... ° C and the apparatus takes about .... minutes to reach it.
To switch off set the temperature control to "0".
Always unplug the device when the device is not used.
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
to cool. If this protection system will start regularly, it is imperative to contact your dealer.
After automatic shutdown, the unit may be commissioned only by pressing the reset button on the unit's back
for this, wait until the temperature drops, press the Reset button.
EN