Selecline DD1-05B-1 Manuel D'utilisation page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Levelling feet
If the refrigerator tilts in some way, adjust the height of the left/right foot (2) of the refrigerator
to be in a horizontal level (
Turn the foot (2) clockwise or counter clockwise to adjust the height.
Note: If the appliance is not level, the door and the door seal will not be closed properly.
Reverse door
Take the following notes before you reverse the door:
• Ensure that the unit is unplugged from the power supply and is empty.
• To take the door off, tilt the unit backwards. Place the unit on a solid surface so that the unit
does not slip during the reversing.
• All removed parts must be kept well to install the door.
• Don't lay the unit horizontally. Otherwise, the coolant system may be damaged.
• It is recommended that two people complete the unit assembly.
To reverse the door, complete these procedures
1. Remove the top right hinge cover (
2. Loosen the screws and remove the hinge bracket (
3. Remove the top left screw cover (
4. Move the core cover from left side to right side. Lift the upper door and place it on a
padded surface to prevent it from scratching (
5. Loosen and remove the bottom hinge pin. Turn the bracket over and replace it (
6. Refit the bracket fitting the bottom hinge pin. Replace both adjustable feet (
7. Place the door back on. Ensure that the door is aligned horizontally and vertically so that
the seals are closed on all sides before you finally tighten the top hinge (
8. Insert the hinge bracket and screw it to the top of the unit.
9. Use a spanner to tighten the hinge as needed.
10. Put the hinge cover and the screw cover back (
Install the door handle
Fig. 9.
Install the rear spacer
Tighten the rear spacers at the rear of the unit (
Positioning
Install this appliance at a location where the ambient temperature corresponds to the climate
class indicated on the rating plate of the appliance. This ensures the correct operation of the
appliance.
Climate class
SN
N
ST
T
Fig. 11).
Fig. 1).
Fig. 3).
Fig. 10).
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
9
Fig. 2).
Fig. 4).
Fig. 8).
EN
Fig. 5).
Fig. 6).
Fig. 7).

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

154589

Table des Matières