ETNA VW247M Mode D'emploi page 72

OPERATION
EN 8
Press the options button twice to activate the extra dry option. When
you activate it, the extra dry indicator will light up and extra heating/
drying steps will be added to the selected program.
Press the button a third time to deactivate the functions, both lights will
switch off.
If an extra feature has been used on the most recent wash program,
this feature will remain active on the next selected program. To cancel
this feature on the newly selected wash program, press the feature
button until the light on the button switches off.
Note! If you decide not to start the selected program, please see the
"Stopping or changing a wash cycle" section.
When there is insufficient softening salt, the salt indicator will light up to
indicate the salt container needs filling. When there is insufficient rinse
aid, the rinse aid indicator will light up to indicate the rinse aid reservoir
needs filling.
Indicators
• Salt.
The indicator shows that you have to fill the salt container with
regeneration salt.
• Rinse aid.
The indicator shows that you have to fill the rinse aid reservoir.
Stopping or changing a wash cycle
1. Open the door.
The last selected program appears on the display.
2. Press and hold the programming button for more than 3 seconds.
The 'End program' indicator is blinking. '1' appears on the display.
3. Close the door of the dishwasher.
The machine pumps out for about 30 seconds. Following the end
of this, an alarm signal will sound and the indicator shows that the
program has finished.
4. You can again select the desired program (see program selection
table).
5. Now close the door.