Perel Tools LEDA301 P Série Mode D'emploi page 5

LEDA301xx-xP/302xx-xP/303xx-xP/305xx-xP
4. Features
floodlight for commercial or residential use
die-cast aluminium housing with tempered glass
ribbed for maximum heat dissipation
with adjustable bracket
with 180° pyroelectric infrared (PIR) motion sensor
suited for outdoor use (IP44)
with 30 cm unterminated cable.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 mounting bracket
2 hinge
3 protective glass
4 LED
5 PIR motion sensor
6. Installation
6.1 Guidelines
The construction to which the device is attached should be able to
support 4 times the weight of the device for one hour without
deformation.
Never stand directly below the device when it is being mounted,
removed or serviced. Have a qualified technician check the device
once a year and once before you bring it into service.
Overhead mounting requires extensive experience: calculating
workload limits, determining the installation material to be used...
Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these
qualifications as improper installation may result in serious
injuries.
This device is not suitable for dimming.
6.2 Distances
Keep at least 50 cm distance at the top and 30 cm on either side.
Respect a minimum distance of 1 m between the device's light
output and any illuminated surface.
V. 01 – 08/07/2013
6 daylight sensitivity control
(LUX)
time adjustment control
(TIME)
detection distance control
(SENS)
5 ©Velleman nv