ProctorSilex 55000 Manuel D'utilisation page 5

Blender Operation – Quick Start Guide
1. Read Important Safety Instructions and Warnings
before use.
2. Place the blender on a dry, level surface.
3. Make sure the power switch is OFF ( ). Plug the
blender into a grounded 3-prong electrical outlet.
4. Place the container on the base with ingredients
and container lid in place.
Sanitizing
Sanitize using 1 tablespoon (15 ml) of household
bleach per 1 gallon (3.8 liter) of clean, cool water
(60°F/16°C), mixed according to the instructions
on the bleach.
1. Fill container with sanitizing solution, replace lid
and emulsion cup, and run on a low speed for
2 minutes. Empty container.
2. Wipe exterior with soft cloth dampened with
sanitizing solution.
Maintenance
Inspect the blender and its various parts and replace as follows:
Daily Unplug the blender, remove the container from the base, and then inspect the container
and cutter assembly for wear, nicks, and broken or loose blades. Replace if necessary. If
the blades are loose, discontinue use immediately and replace cutter assembly. Do not
attempt to repair or tighten the cutter assembly.
Weekly Unplug the blender, and then inspect the power cord insulation and power plug for
cracks. Refer to "Technical Services" for repair or replacement. Remove jar from blender
base. Inspect the cutter by rotating the drive end of the cutter by hand. It should turn
smoothly. If it does not, replace the cutter assembly.
5. Press the RESET (I)/OFF ( ) (Power) switch to turn
on the blender.
6. Adjust the variable speed dial to the desired speed.
7. Select the desired blending time (:15, :20, :30,
:45).
14 15
3. Immerse lid and emulsion cup in sanitizing solution
for 2 minutes. Place empty container on base and
run on a high speed for 2 seconds to remove any
moisture from the cutter assembly.
4. When ready to use, rinse with clean water.
5