UMBRA RIMORCHI 28055 Instructions De Montage page 7

Remove below the vehicle any mastic from contact points between the chassis and the towbar; then paint
have to be made.
1. Remove the rear bumper and the inner reinforcement bar;
2. Remove the spare wheel and the exhaust pipe bearing loosing the rubber caps;
3. Drill the car's body to Ø12 mm referring to the burins placed in position "3";
4. On the opposite side eliminate the plastic stoppers from the holes "3" and then widen them to Ø18 mm
(the side towards the engine only);
5. Place the cross bar "C" lined up with the rear body, referring to the holes "3" and "4" and insert the
screws;
6. On the opposite side insert the spacers "B" inside the holes "3" and insert the given cage-nuts referring
to the holes "1" and "2" of the chassis-rails;
7. Place the tie rods "A" (the short one and the long one) under the respective vehicle's chassis-rails
referring to the holes "1" and "2", and lined up to the rear side referring to the holes "3" and "4", then
8. Tighten all bolts and nuts as shown in the enclosed layout;
9. Connect the wiring to the socket, following the car booklet's instructions "use and maintenance" as
shown in the enclosed wiring kit layout;
10. Make a cut on the lower central side of the bumper, as shown in the enclosed "LAYUOT";
11. Reassemble the exhaust pipe bearing, the spare wheel, the reinforcement bar and the rear bumper.
INVISIBLE AND SWIVELING SOCKETHOLDER ONLY FOR TYPE "C" AND "VM"
• Make sure that the tow bar is suitable for the vehicle before starting the installation. Verify also that
the vehicle's towing disposal quoted on the car registration is mentioned on the tow bar document.
documents.
• For safety, all work involving tow bar installation must be undertaken by skilled technicians.
•
•
• The tow ball must be kept clean and lubricated. For added safety, his diameter (50 mm) must be
checked at regular intervals. If the tow ball measures less than 49 mm after selected readings across
the diameter, the tow ball must be replaced with a new one.
• After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table.
www.umbrarimorchi.it - umbrarimorchi@umbrarimorchi.it
FITTING INSTRUCTIONS
SAFETY INSTRUCTIONS
umbrarimorchi@umbrarimorchi.it) for explanations or updated
USE AND MAINTENANCE
Cod. 28055 • Rev. 1.0 • 01/01/2011
tel. +39 075 5280260 - fax +39 075 5287033
.
7