DeWalt DCE300 Guide D'utilisation page 13

2. Final maintenance warning at 14,900 cycles
(Maintenance LED flashes yellow continuously)
3. Needs service at 15,000 cycles (Maintenance LED lights
red for 10 seconds then turns tool off automatically).
At 15,000 cycles, the tool will no longer run. Take your
tool to a local dealer or authorized service center for
maintenance and recalibration.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Regularly clean the die holder and ram head to be sure they
are free of dirt and debris to ensure a proper crimp.
Accessories

WARNING: Since accessories and dies, other than
those offered or recommended by D
been tested with this product, use of such accessories
or dies with this tool could be hazardous. To reduce
the risk of injury, only D
accessories and dies should be used with this product.
Recommended accessories and dies for use with your
tool are available at extra cost from your local dealer or
authorized service center. If you need assistance in locating
any accessory or die, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D WALT (1-800-433-9258) or visit our website:
e
www.dewalt.com.
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D WALT factory service center
e
or a D WALT authorized service center. Always use
e
identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
COnFiRMATiOn OF OWnERshiP: In case of
•
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
• FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
WALT, have not
e
WALT-recommended
e
WALT Industrial
e
notification is required under the Federal Consumer
Safety Act.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to
e
faulty materials or workmanship for three years from the
date of purchase. This warranty does not cover part failure
due to normal wear or tool abuse. For further detail of
warranty coverage and warranty repair information, visit
www.dewalt.com or call 1-800-4-D
This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and
you may have other rights which vary in certain states
or provinces.
In addition to the warranty, D
by our:
1 YEAR FREE sERViCE
D WALT will maintain the tool and replace worn parts
e
caused by normal use, for free, any time during the first year
after purchase.
2 YEARs FREE sERViCE On DEWAlT BATTERY PACKs
DC9071, DC9091, DC9096, DC9182, DC9280, DC9360, DCB120,
DCB127, DCB201, DCB203, DCB203BT, DCB207, DCB361
3 YEARs FREE sERViCE On DEWAlT BATTERY PACKs
DCB200, DCB204, DCB204BT, DCB205, DCB606
nOTE: Battery warranty voided if the battery pack is
tampered with in any way. D
for any injury caused by tampering and may prosecute
warranty fraud to the fullest extent permitted by law.
90 DAY MOnEY BACK gUARAnTEE
If you are not completely satisfied with the performance of
your D WALT Power Tool, Laser, or Nailer for any reason, you
e
can return it within 90 days from the date of purchase with
a receipt for a full refund – no questions asked.
lATin AMERiCA: This warranty does not apply to products
sold in Latin America. For products sold in Latin America,
see country specific warranty information contained in
the packaging, call the local company or see website for
warranty information.
FREE WARning lABEl REPlACEMEnT: If your warning
labels become illegible or are missing, call 1-800-4-D
(1-800-433-9258) for a free replacement.
sPECiFiCATiOns
DCE300
Battery pack
Nominal Crimping Force
Operating Temperature Range
English
WALT (1-800-433-9258).
e
WALT tools are covered
e
WALT is not responsible
e
WALT
e
20V Max*
12 Tons (106kN)
14 °F–158 °F (-10 °C–70 °C)
11