Installation And Use; Safety Instructions; Use - Casselin CFRQP1 Mode D'emploi

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current !
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current !
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
START-UP
The device must be completely removed from its packaging. All protections must be completely removed.
Place the unit upright on a solid, flat surface. Never place the device on a flammable surface.
Do not install the oven near open fires, or other heating devices.
It is forbidden to place inflammable objects on the device or within 10 cm of the device.
Safety distances for flammable materials according to their degree of flammability :
AT non-flammable : granite, stoneware, concrete, bricks, ceramic tiles, plaster.
B hardly flammable : acumin, heraclite, lihnos, itaver.
C1 poorly flammable : wood from deciduous trees, plywood, hardened paper, umakart.
C2 medium flammability : chipboard, solodur, cork, rubber, coatings.
C3 easy flammability : wood fiber boards, polystyrene, polyurethane, PVC.
The electrical cable should be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a multiple socket will cause the device to trip.
When the appliance is placed against a wall, it must be able to withstand a temperature of 60 ° C. If this is
not the case it is essential to insert a protective layer.
Make sure that all ventilation openings are not blocked.
Thoroughly clean all parts of the appliance before use with a suitable product. The control box must not come
into contact with water or humidity.
Make sure that the device is placed so that the user has sufficient space to operate it.
ELECTRICAL HAZARD !
Danger from electric current !
The device can cause injury if installed improperly. Before proceeding with its installation, compare the data
of the local electrical network with the indications given on the nameplate of the appliance. Only connect the
device if there is compliance. Observe the safety rules.
EN