Makita 9553NB Manuel D'instruction page 5

• Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, slide the slide switch toward the "I (ON)"
position. For continuous operation, press the front of the
slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing side grip (handle)
CAUTION:
• Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool as
shown in the figure.
Installing or removing wheel guard
9553NB
2
9554NB/9555NB
2
005804
005805
1. Wheel guard
1
2. Screw
3
3. Bearing box
005807
1. Wheel guard
1
2. Bearing box
3. Screw
3
CAUTION:
• When using a depressed center grinding wheel/
Multi-disc, flex wheel, wire wheel brush or cut-off
wheel, the wheel guard must be fitted on the tool so
that the closed side of the guard always points
toward the operator.
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees. Be
sure to tighten the screw securely.
To remove wheel guard, follow the installation procedure
in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc
1
2
3
WARNING:
• Always use supplied guard when depressed center
grinding wheel/Multi-disc is on tool. Wheel can
shatter during use and guard helps to reduce
chances of personal injury.
Mount the inner flange onto the spindle. Fit the wheel/
disc on the inner flange and screw the lock nut onto the
spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
To remove the wheel, follow the installation procedure in
reverse.
5
001070
1. Lock nut
2. Depressed cen-
ter grinding
wheel/Multi-disc
3. Inner flange
005917
1. Lock nut wrench
2. Shaft lock