Table des Matières
Publicité
General information:
Please read the installation instructions before beginning with the installation!
Keep the installation instructions handy for further use.
All work should be performed by experienced, qualified personnel.
The manufacturer accepts no responsibility if these installation instructions are not followed.
The manufacturer accepts no liability and acknowledges no claims for damages or guarantee claims
concerning damages resulting from incorrect installation (e.g., insufficient wall reinforcement, insufficient
sealing against water splashes).
The installation materials are not included in the scope of supply.
Select installation materials to suit the wall.
Please observe and check the warnings.
Failure to observe the warnings can result in injury to the installer or third parties.
Failure to observe the warnings can result in material damage to the product.
These instructions do not replace national accident prevention regulations and the latter must always take
precedence over them.
In case of difficulties which cannot be resolved with the aid of the installation instructions, please contact
the manufacturer or supplier.
All installation and connection dimensions can be found in the planning documents.
Important safety information in these installation instructions is indicated using symbols as follows:
Danger! Live current!
Indicates risks which can
result in severe injury or
death.
Works on live components may
only be carried out by qualified
electricians or similarly qualified
persons!
Electrical components must be installed
according to national, European and
international directives and standards.
Always observe the local standards and
regulations concerning wet room protection
zones and the low-voltage directive.
Electrical components in wet rooms or other
specifically designated rooms must be installed
in accordance with the standards.
Disconnect electrical components from the
mains before installation.
Make sure that no components carry live
voltage.
Secure the power supply against accidental
connection.
Observe the country-specific protection zones
for wet rooms.
Prevent direct contact with water, e.g. when
showering.
Alape˘ | A˘ system
Caution!
!
Indicates risks which can
result in material damage
or minor injuries.
!
Caution!
Ensure secure installation.
The on-site wall reinforcement must
be verified.
Payload of 150kg plus actual weight
of washstand.
Select installation materials to suit the
wall.
The wall plugs for the installation are
not included in the scope of supply.
Note!
!
It is essential to comply with the dimensions
specified in the planning
documents.
Note!
Uneven walls can create gaps which cannot
!
be adjusted.
Prior to starting the installation, ensure that
the wall is flat.
Smooth out uneven walls using appropriate
means.
Note!
!
Indicates risks which
could possibly result
in material damage.
EN
150
KG
3 | 44
Publicité
Table des Matières
