Termozeta IONO Silver air Mode D'emploi page 9

• Cleaning and user maintenance shall not be made by children without supervision.
• The power cord of the appliance should never be replaced by the user himself.
In case of necessity contact our service center calling toll-free Number 800
200 899.
• In case of failure and/or malfunctioning of the appliance, turn it off and do
not tamper with it. For any repairs contact our service center calling toll-free
Number 800 200 899 and ask for the use of original spare parts.
• At the end of the life-cycle of the appliance, put it out of service by cutting the
power cord after disconnecting the plug from the outlet. For the disposal of the
appliance follow the regulations which are valid in your place of residence.
• LANGE DISTRIBUTION cannot be considered responsible for any damage to
persons, animals or things caused by the incorrect installation or as a result of an
illegitimate, mistaken or unreasonable use.
ATTENTION!
• Never use the appliance near bathtubs, washbasins, containers, etc.
full of water or other liquids.
• Never use hairspray while the appliance is running.
• Make sure that your hands and feet are dry and that your hair is not excessively
wet.
• To ensure the utmost safety, we recommend installing a residual current
device in the electrical circuit that supplies power to your bathroom. The
rated operating differential current should not exceed 30 mA. Contact your
electrician for further information.
• If the hairdryer is used in the bathroom, always disconnect it from the mains
power after use because the proximity to water may be dangerous even when
the appliance is OFF.
INITIAL START-UP
• Completely unwind the power cord (8) and connect the plug to a suitable socket outlet.
temperature control switch (1b) and then start drying your hair.
• If you need to set your hair during drying, press the cold-shot button (2) while the
• To speed up drying time, press the intense air button (5) while the appliance is switched
on: the air released will be much faster and intense.
• After use, turn off the appliance by bringing switch (1a) to the 0 position and disconnect
ENGLISH