Storage And Cleaning - Bartscher 292.480 Mode D'emploi

EMISSION STRENGTH
The infrared thermometer comes factory preset at an emission strength of 0.95.
This value can be changed by 0.10 (10E) up to 1 (100E). These changes can be
made only by specially-trained personnel. Information concerning emission
levels of particular materials can be received from your local sales agent.
Tip: The touch-free infrared thermometer should not be used for measuring
temperatures of shiny or polished metallic surfaces. To change the emission
strength, press ⑥-②* five times -⑥ for each change of 0.01 (1 E) -②.
Touch thermometer function (COT mode)
Insert the needle sensor ① into the object being measured and press ⑦ to
display the temperature for up to 4 minutes. After this time, the unit will
turn off automatically to save battery power. Pressing ⑦ will stop the
measurement and display the last temperature along with the message
"Hold". To resume measurement, press ⑦ again.
1. Do not bend or rotate the needle sensor in the wrong direction.
2. Placing too much pressure on the sensor may cause damage.

STORAGE AND CLEANING

The sensor lens is the most sensitive element of the thermometer, and as
such must be kept clean. Clean the device carefully, using a soft cloth or
cotton swab dipped in water or pharmaceutical alcohol. Wait for the lens
to dry thoroughly before using. Do not immerse the thermometer in
fluids. Store the unit at temperatures between -4°F and +149°F
(-20°C and +65°C).