Palmer PWT06 Manuel D'utilisation page 5

controlS
1
4 5
1
Status indicators:
These leDs indicate the status of the respective channel.
Green: oK
red: failure (short-circuit, overload, wrong polarity)
2
power lEd:
lights up when the unit is on.
3
power switch:
Power switch for turning the unit on and off.
4
power input socket:
Connect the included power cord here.
5
voltage selection switch:
Use this switch to set the device to the available mains voltage (110v/60Hz or 230v/50Hz). Generally, it is
never necessary to move this switch. it is preset to the voltage of the country in which the device was pur-
chased. Before using it for the first time, however, make certain that this setting is correct.
6
6x dc outputs
8
2
3
6
output chAnnEl In dEtAIl
1 2
1
polarity:
set the polarity of the output here. For the correct polarity, consult the manual for the device that you want to
connect or the information printed on the device.
2
output voltage selection switch:
Use this to select the output voltage (DC) required by the device to be connected.
3
power out:
output socket for the DC voltage: Connect a DC cable here.
cAutIon: to avoid damage, always set the polarity and output voltage bEForE connecting the
device.
3
9