Safety - Thermador VTI1010P Manuel D'installation

Safety

IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT: Save these Instructions for the Local Gas
Inspector's use.
INSTALLER: Please leave these Installation Instructions
with this unit for the owner.
OWNER: Please retain these instructions for future
reference.This appliance conforms to the relevant safety
regulations.
Repairs should only be carried out by qualified specialists.
Check if this blower is recommended by the manufacturer
to be installed with the hood.
WARNING
To avoid electrical shock hazard, before installing,
switch power off at the service panel and lock the panel
to prevent the power from being switched on
accidentally.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
a) Installation work and electrical wiring must be done
by qualified person(s) in accordance with all
applicable codes and regulations, including fire-
related construction.
b) Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturers
guideline and safety standards such as those
published by the National Fire Protection
Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
c) When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
d) To properly exhaust air, be sure to duct air outside.
DO NOT vent exhaust air into spaces within walls,
ceilings, attics, crawl spaces, or garages.
CAUTION
FOR GENERAL VENTILATING USE ONLY. DO NOT
use to exhaust hazardous or explosive materials and
vapors.
WARNING
To reduce the risk of fire or electric shock, do not use
this blower with any solid-state speed control device.
WARNING
State of California Proposition 65 Warnings:
This product contains chemicals known to the State of
California to cause cancer, birth defects or other
reproductive harm.
WARNING
To reduce the risk of fire, use only metal ductwork.
Grounding instructions
This appliance must be grounded. In the event of an
electrical short-circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
WARNING
Improper grounding can result in a risk of electric shock.
Consult a qualified electrician if the grounding
instructions are not completely understood, or if doubt as
to whether the appliance is properly grounded.
None of the packing materials cause pollution to the
environment and all can be recycled for use again. Please
help to protect the environment and dispose of the
packaging in an environment-friendly manner.
Remove all tape and packaging before using the appliance.
Destroy or recycle the packaging after unpacking the
appliance.
Never allow children to play with packaging material.
English 1