Perel CSOLCRW Mode D'emploi page 6

Installation
1.
2.
3.
4.
5.
Working Mode
1.
2.
3.
V. 01 – 03/04/2019
CSOLCRW
Use the card to measure the position of the holes correctly.
Drill two holes.
Insert a nylon plug in each hole.
Insert a screw in the lower nylon plug and tighten slightly.
Insert the lower notch of the lamp onto the screw.
Straighten the lamp and fasten the upper screw.
Press the mode button to adjust the working mode.
Press the mode button twice to enter mode B. This mode
automatically switches on at dusk (< 30 lux) to 20 %
brightness. It is switched on up to 5 hours after which it
switches off.
Press the mode button twice to enter mode B. This mode
automatically switches on to full brightness when a motion
has been detected. It switches to weak brightness for
20 seconds after the last motion detection.
Press the mode button three times to enter mode C. This
mode automatically switches on to full brightness when a
motion has been detected. It switches off 30 seconds after
the last motion detection.
6 ©Velleman nv