Bosch PMF 10,8 LI Notice Originale page 19

OBJ_BUCH-1170-002.book Page 19 Tuesday, May 11, 2010 3:36 PM
Use suitable detectors to determine if utility
lines are hidden in the work area or call the
local utility company for assistance. Contact
with electric lines can lead to fire and electric
shock. Damaging a gas line can lead to explo-
sion. Penetrating a water line causes property
damage or may cause an electric shock.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Do not open the battery. Danger of short-
circuiting.
Protect the battery against heat, e.g.,
against continuous intense sunlight,
fire, water, and moisture. Danger of
explosion.
In case of damage and improper use of the
battery, vapours may be emitted. Provide
for fresh air and seek medical help in case
of complaints. The vapours can irritate the
respiratory system.
Use the battery only in conjunction with
your Bosch power tool. This measure alone
protects the battery against dangerous over-
load.
Use only original Bosch batteries with the
voltage listed on the nameplate of your
power tool. When using other batteries, e. g.
imitations, reconditioned batteries or other
brands, there is danger of injury as well as
property damage through exploding batteries.
Wear protective gloves when changing ap-
plication tools/accessories. Application
tools/accessories become hot after pro-
longed usage.
Do not scrape wetted materials (e. g. wall-
paper) or on moist surfaces. Penetration of
water into the machine increases the risk of
an electric shock.
Bosch Power Tools
Do not treat the surface to be worked with
solvent-containing fluids. Materials being
warmed up by the scraping can cause toxic
vapours to develop.
Exercise extreme caution when handling
the scraper. The accessory is very sharp;
danger of injury.
Functional Description
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or
serious injury.
Intended Use
The machine is intended for sawing and cutting
wooden materials, plastic, gypsum, non-ferrous
metals and fastening elements (e.g., unhard-
ened nails, staples). It is also suitable for work-
ing soft wall tiles, as well as for dry sanding and
scraping of small surfaces. It is especially suita-
ble for working close to edges and for flush cut-
ting. Operate the power tool exclusively with
Bosch accessories.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Battery unlocking button
2 Battery*
3 Thumbwheel for orbit frequency preselection
4 Battery charge-control indicator
5 On/Off switch
6 Venting slots
7 Tool holder
8 Handle (insulated gripping surface)
9 Plunge saw blade*
10 Clamping bolt with washer
11 Allen key
12 Sanding plate*
13 Sanding sheet*
2 609 004 157 | (11.5.10)
English | 19