Brandt VI 320 Guide D'utilisation page 27

Présentation de votre lave-vaisselle Troubleshooting, what to do?
Poor operation Possible causes
A lot of residue left on - The drain hole and the
the main filter at the end filters are blocked by
of the cycle. too much residue.
Steam appears approx. - The steam from drying
20 minutes before the is in contact with a flow
end of the cycle (model of cold air.
with ventilated drying).
Poor washing results Possible causes
Traces of food, deposits, - The washing up has
"grains of sand" in the been badly arranged
glasses. (items masked by
another, larger item or
placed under it, items
side by side or nesting
together).
- The upper agitator is
blocked by cutlery,
plates, etc.)
- The filter is not screwed
in tightly and is lifting
during washing
- The micro-filter's sieve
is clogged.
Greasy marks. - Too little detergent,
poor detergent, stale
detergent.
- Unsuitable programme
(temperature too low,
not long enough).
50
What to do
- Remove the filters and
clean them and the drain
hole. Remove any large
amounts of residue from
the plates before placing
them in the dishwasher.
- A normal but infrequent
occurrence only when
drying starts (connec-
ted with the temperatu-
re of the room,
draughts, etc.).
What to do
- Arrange the items cor-
rectly; use the most sui-
table areas and acces-
sories for each type of
item (see Operating
Instructions).
- Check that the agitator
rotates freely (sizing
wire), set the basket to
the High position if nec-
essary.
- Check the seating and
the tightness of the fil-
ter (screw it in fully to
the right).
- Remove and clean all the
filters (with warm water),
including the sieve.
- Increase the amount of
detergent; try another
detergent.
- Select a programme
with a higher tempera-
ture.
GB
Présentation de votre lave-vaisselle Troubleshooting, what to do?
Poor washing results Possible causes
White marks - Chalky film (can be
(Identify the nature of removed with vinegar).
the marks)
- Traces of salt
(item ahs a salty taste)
- Opalisation of the glass
because water too soft
(cannot be removed).
Coloured marks (tea, - Items poorly arranged
wine, coffee, blood)
- Not enough or poor
detergent
- Programme with too
low a temperature.
Run marks or dried - Insufficient or no rinse
droplets on the glasses aid.
- Poor or out-of-date
rinse aid.
GB
What to do
- Check that there is salt
in the reservoir (light
unlit = OK)
- Check the water hardness
at the tap and that the
water softener is set cor-
rectly. Set it on a higher
setting if necessary.
- Water too hard for using
a "3 in 1" detergent
recommended.
- Check that the salt pot's
stopper is firmly closed.
- Check the water hard-
ness at the tap and that
the water softener is
set correctly. Some
detergent tablets are
more aggressive to
glasses and decorations
(change the detergent,
use a protective product
if necessary).
- Turn the open ends (of
glasses, bowls, etc.)
towards the jets
- Increase the amount of
detergent
- Select a more suitable
programme, with a
higher temperature.
- Check the indicator light
and fill the reservoir
completely, set the dis-
penser to the upper
position if necessary.
- Replace with a recent
agent (a good rinse aid
dilutes easily and foams
in cold water).
51