Husqvarna HD800AWD/BBC Manuel De L'opérateur page 14

ENGINE
Maintenance, repair, or replacement of the emission control
devices and systems, which are being done at the custom-
ers expense, may be performed by any non-road engine
repair establishment or individual. Warranty repairs must
be performed by an authorized engine manufacturer's
service outlet.
LUBRICATION
Use only high quality detergent oil rated with API service
classification SJ–SN. Select the oil's SAE viscosity grade
according to your expected operating temperature.
NOTE: Multi-viscosity oils (5W30, 10W30 etc.) improve
starting in cold weather, and you should check your engine
oil level frequently to avoid possible engine damage from
running low on oil.
Change the oil after every 25 hours of operation or at least
once a year if the lawn mower is not used for 25 hours in
one year.
Check the crankcase oil level before starting the engine
and after each five (5) hours of continuous use. Tighten oil
plug securely each time you check the oil level.
TO CHANGE ENGINE OIL (See Figs. 18 & 19)
NOTE: Before tipping lawn mower to drain oil, empty fuel
tank by running engine until fuel tank is empty.
1. Disconnect spark plug wire from spark plug and place
wire where it cannot come in contact with plug.
2. Remove oil fill cap/dipstick; lay aside on a clean sur-
face.
3. Tip lawn mower on its side as shown and drain oil into
a suitable container. Rock lawn mower back and forth
to remove any oil trapped inside of engine.
MAINTENANCE
CONTAINER
FIG. 18
4. Wipe off any spilled oil from lawn mower or side of
engine.
5. Fill engine with oil. Slowly pour oil down the oil fill
spout into the engine.
6. Wait one minute to allow oil to settle. Use guage on
oil fill cap/dipstick for checking level. Insert dipstick
into the tube and rest the oil fill cap on the tube. DO
NOT thread the cap into the tube when taking reading.
OIL FILL CAP /
DIPSTICK
UPPER
MARK
LOWER
MARK
7. Continue adding small amounts of oil and recheck-
ing the dipstick until it reads full. DO NOT overfill, or
engine will smoke on startup.
8. Always be sure to retighten oil fill cap/dipstick before
starting engine.
9. Reconnect spark plug wire to spark plug.
AIR FILTER (See Fig. 20)
Your engine will not run properly and may be damaged
by using a dirty air filter. Replace the air filter every 100
hours of operation or every season, whichever occurs first.
Service air cleaner more often under dusty conditions.
TO CLEAN AIR FILTER
1. Remove cover.
2. Carefully remove cartridge.
3. Clean by gently tapping on a flat surface. If very dirty,
replace cartridge.
CAUTION: Petroleum solvents, such as
ker o sene, are not to be used to clean
car tridge. They may cause de te ri o ra tion
of the cartridge. Do not oil car tridge.
Do not use pres sur ized air to clean or
dry car tridge.
4. Install cartridge, then replace cover.
14
FIG. 19