Useful Advice - Indel Webasto Isotherm TB31 Instructions D'utilisation

TB 31-41-51
USE
- Plug in the DC or AC power. Press the button `ON/OFF` to run the refrigerator. The LED display on the
control panel would be lighted and the interior temperature would be displayed.
- Press the button Δ and ∇ to adjust the temperature. Press the button Δ to increase while the button ∇
to decrease the temperature. When press the above two buttons at the same time, it would switch the
display between °C and °F.
- Press the ECO key to enter the "ECONOMY" operating mode: the ECO light turns on and the com-
pressor runs at minimum speed by keeping a fresh temperature inside the refrigerator. By pressing the
ECO key again, the light turns off and the refrigerator enters in MAX mode (mode (maximum number of
compressor turns). MAX light will be switched on until having acheved the temperature set.

USEFUL ADVICE

1) Use the product in MAX mode in these cases:
- use of the product as refrigerator with high ambient temperature;
- when the suitable temperature need to be achieved in few time.
2) Use the product in ECO mode in these cases:
- use of the product as refrigerator and, in particular, with low ambient temperature;
- when the vehicle is parked for long time (with engine switched off)
FILLING
Do not put hot food items into the refrigerator. Place the products in such a way as to avoid them hitting
against each other or breaking because of the movement of the vehicle.
Make sure that the lid is always well closed and open it for as short a time as possible.
DEFROSTING
Defrosting is needed when the layer of frost is thicker than 4 mm.
To carry out this operation, turn off the refrigerator.
Do not use sharp or cutting tools to remove the layer of frost or ice.
Wait until complete unfreezing and then turn on again.
CG V.1.0 02042015
ENGLISH
13