Orbegozo DH 250 Mode D'emploi page 10

DH 250
*To avoid electric shock.Do not open.There are no userserviciable parts inside.
*Any repair work must be done by qualified technician appointed by our distributors.
*Specifications are subject to change for improvement without prior notice.
SPECIFICATIONS
Moisture removal: Approximately 250ml per day at 30ºC,80% RH
Cooling Element: Thermo-electric Peltier module.
Fan: 80x80mm high speed long life DC brushless motor with turbo blades.
A.C. / D.C. power supply: 9V DC 2.6Amp.
Power consumption: 23.4W
Water tank capacity: 500ML
Water level Detector: Automatic switch off with 'Yellow' LED indicator when water tank is full.
Product dimension: 154mm (W)x218mm(H)x130mm(D)
Working environment: Over 15º C, over 40% RH.
CONNECTION
1. After removing the packiging materials, there should be 2 items:
a. Midi dehumidifier.
b. AC/DC Power adaptor.
2. Plug the DC power jack (11) of the switching mode power supply to the DC power socket (7),then connect
the AC plug(11) of the switching mode power supply to the appropriate main socket.
3.Press the 'On/ Off 'button(1) to 'On' position, the midi dehumidifier will begin to operate.The green LED will
be turned on.Listen and feel for the air blowing form dry air outlet(fig 1).
4. To switch off the unit press'on/off' button(1) to 'Off' position, the midi dehumidifieer will be turned off.(as
fig.2).
REMOVABLE WATER TANK
When the water tank is full, with approximately 1.5 litre of wáter collected, the unit will be switched off
automatically and the 'Yellow' LEd (3) will be on (as fig.3)
To remove the water tank, first switch off the Midi dehumidifier, press 'On/Off' button to the 'Off'
position.Then,remove the water tank from the unit and pour the water out to the toilet or bathroom.Put the
water tank back into the unit.To continue dehumidifying,press the 'On/Off' button to 'On' position again.
10