Maintenance And Troubleshooting; Specifications; Customer And Technical Service - QEP 21665Q Manuel D'utilisation

OPERATING INSTRUCTIONS -
e. Run the mixer at low speed using the variable speed dial until the dry
material and water are evenly distributed. Do not run the mixer at high
speed if it appears to be slowed down or labored. If the mixer begins to heat
up, allow it to cool, then run at a lower speed.
f. When finished mixing, remove the mixing paddle from the mixer. Wipe any
water, mud or debris from the mixer with a clean, dry cloth. Wash the
mixing paddle with clean water. Do not allow grout, mortar or paint to dry
on the mixing paddle.

MAINTENANCE AND TROUBLESHOOTING

CAUTION: Be sure to switch power OFF and disconnect the plug during maintenance
and inspection.
1. Use a mixing paddle appropriate for the material you are mixing.
2. This power mixer normally requires little maintenance. It is suggested that
the ventilation space between the gear box and the motor be cleared of
debris after each use.
3. After approximately 100 hours of use, check the motor brushes and replace,
if necessary.
4. Store mixer in a dry place that will not freeze.

SPECIFICATIONS

Motor Unit:
No Load Speed:
Mixing Paddle:
Double Insulated

CUSTOMER AND TECHNICAL SERVICE

For customer and technical service please go to www.qep.com
or call tollfree 1-866-435-8665.
Power Input: 1300 Watts
Voltage: 120V-60HZ
Low: 180-460 RPM, High: 300-700 RPM
Certification: ETL
127 mm (5")
Weight: 13 lbs., 9oz
CONTINUED
- 7 -