EINHELL TH-OS 1520 Mode D'emploi D'origine page 16

6. Operation
6.1 Switching the machine on and off
(Fig. 7/Item 2)
To switch on:
Slide the operating switch (2) forwards.
To switch off :
Slide the operating switch back into its initial po-
sition
6.2 Working with the orbital grinder/sander
•
Place the whole surface area of the sanding
disk on the material.
•
Switch on the machine and move it with gent-
le pressure over the workpiece completely
circular movements or moving it to and fro
and up and down.
•
Use a coarse paper for coarse sanding and a
finer paper for finish sanding. You can find the
best paper for the job by means of testing.
Important.
The dust generated when working with the machi-
ne may be harmful.
•
Always wear goggles and a dust mask when
carrying out sanding/grinding work.
•
Everybody who uses the machine or enters
the workplace must wear a dust mask.
•
Do not eat, drink or smoke at the workplace.
•
Do not use the machine on paints which con-
tain lead.
7. Replacing the power cable
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_TH_OS_1520_SPK1.indb 16
GB
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 16 -
9.
The
ven
mat
recy
mad
and
you
be t
disp
suc
loca
10
Sto
chil
free
ratu
too
16.09.13 15:05