Chain; Plastic Parts - BERG JEEP Buzzy Rubicon Mode D'emploi

3.2.4 Chain

The product has a driving mechanism with one chain, which needs proper maintenance.
Make sure that the chain is sufficiently oiled so it can run smoothly.
If a chain is too tightly tensioned, the product will be more difficult to pedal and there is a big chance
that wear and tear of the chain and sprocket, among other things, will occur faster. If a chain is not
tight enough, the chain can easily come off the sprocket, or there is a chance of damage to the chain
housing.
To tension the chain:
• Remove the plastic chain guard by loosening the bolts on the front side and the bolt on the rear
side.
• Untighten but do not remove the four bolts on the bottom side near the front sprocket.
• Tension the chain by moving the pedal axle forwards and hold it tight.
• The chain has the correct tension if the middle can be pushed 6 millimeters downwards.
• Tighten the four bolts again. Keep the sprocket wheel parallel to the chain guard.
• Mount the chain guard when the chain has the correct tension.
• The chain guard has to be removed to grease the chain and check the chain tension.
4x

3.2.5 Plastic parts

The plastic parts must be checked regularly for damage and breakage.
In the case of breakage you must immediately replace the part concerned with an original part, in
order to guarantee the safety of the user.
14
JEEP Buzzy
4x