D-Link DWR-953V2 Guide D'installation page 4

PRoDuCT SETuP
Ensure that your DWR-953V2 LTE Cat4 Wi-Fi AC1200 Router is powered off before performing the
steps below.
Router
SIM
card
Router
Router
PC
Router
PC
2
Step 1:
If you are connecting to a LTE connection, insert a standard
USIM card into the SIM card slot on the side of the router.
Note: Do not attempt to insert a Nano SIM or Micro SIM into the SIM
card slot.
Step 2:
Modem
If you are connecting this router to a modem, insert one end of
an Ethernet cable into the Gigabit WAN/LAN port on the back of the
router and the other end into your wired Internet connection device.
Note: When connected to a modem, by default, the LTE connection
will be used as the main WAN connection. The router will
automatically use the wired connection if the LTE connection is not
available.
Step 3:
Modem
Insert the supplied Ethernet cable into a LAN port on the back panel
of the DWR-953V2, and an available Ethernet port on the computer
you will use to configure the unit.
Step 4:
Modem
Connect the power adapter to the power input on the back panel of
your DWR-953V2 LTE Cat4 Wi-Fi AC1200 Router. Plug the other
end of the power adapter into a wall outlet or power strip and press
the power button down.
The POWER LED on the router will light up to indicate that power is
being supplied to the router.
Step 5:
To configure the DWR-953V2 LTE Cat4 Wi-Fi AC1200 Router:
Open a web browser window and enter 192.168.0.1 into the address
bar.
Enter admin for the username and leave the password area blank.
DWR-953V2