Installation; Operation - Opus Technologies OP-10CH36 Manuel D'installation Et D'utilisation

OP-10CH36 | Manuel d'installation et d'utilisation | Installation and user manual |

3. Installation

Open the three snap locks on the box cover:
press the light gray unlocking handle at the clo-
sure, pull up the closure on the handle so that it
is up. Position the transmitters / receivers.
Close the lid carefully, close the snap locks. The
two side closures can be locked with the deli-
vered key and the central lock via a combination
lock. The opening combination out of the facto-
ry is "000". To set the combination lock to ano-
ther personal combination, do the following:
1) Set the number wheels of the lock to the cur-
rent opening combination and open the lock.
2) On the back of the combination lock, push
the small metal lever to the right and bottom
and engage it.
3) With the number wheels, set a new opening
combination.
4) Disengage the metal lever so that it returns
to its original position. The lock is now set to the
new opening combination.
5) Close the snap lock, set a different combina-
tion of numbers than the opening combination
on the lock to lock it.
Via the telescopic handle, you can move the box
like a trolley: to unfold / fold the handle, press
its light gray unlocking button. The accessories
can be stored in the case on the underside of
the case.

4. Operation

4.1 Charge the accumulators of the
transmitters / receivers
1) Open the box.
Attention, warning, danger:
To prevent overheating of the char-
ging box, do not close the cabinet
while charging!
2) Place the transmitters / receivers in the char-
ging compartments, load contacts facing down-
wards. When positioning them, be sure to fully
push the devices into the compartment so they
are securely fixed.
3) A power supply is delivered with the box
(with separate power cable), fixed in the box
with Velcro for transport. Connect the power
supply unit to the DC INPUT socket of the
boxand then connect it via the mains lead to a
230 V ~ / 50 Hz socket. The operation indicator
on the power supply unit lights up.
4) To turn on the charging function, turn the
switch to ON (the switch shines).
5) As long as a charging compartment is empty,
its charging indicator flashes. When the battery
of a device is charged into a compartment, its
charge indicator lights up continuously.
Note:
If a charge indicator flashes while char-
ging, the charging box performs a self
test to protect the battery.
18