User Manual - Toolland PM3115 Notice D'emploi

1. Introduction
Thank you for choosing Toolland! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer. Damage
caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
2. Safety Instructions
Keep away from children and unauthorised users.
Always wear a suitable dust mask during use.
Always wear protective gloves during use.
Always wear protective eyeglasses during use.
The grinder disc and work piece may become extremely hot. Do not touch with bare
hands.
Do not use in an explosive atmosphere.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
• Protect this device from shocks and abuse. Avoid brute force when operating the device.
• Protect the device against extreme heat, dust and moisture.
• Familiarise yourself with the functions of the device before actually using it.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• Damage to grinder, grinding disc, work pieces or any personal injury resulting from the use of this
device is not covered by the warranty.
4. Features
• suitable for angle grinders with 115/125mm disc
• base with holes for secure bench mounting
• adjustable holding angle
• easy to assemble
5. Overview
Refer to the illustrations on page 2 of this manual.
1 lever
2 lateral support
3 grinder holder
4 grinder support bolt (M10)
5 grinder support bolt (M8)
6. Assembly
Refer to the illustrations on page 2 of this manual. Required tools (not included):
Wrench:
•
• Hex key:
• [A] Mount the grinder holder [3] on the base [10] using 2 bolts, nuts and washers
• [A] Mount the lever [1]
• [A] Screw the lateral supports [2] into the threaded openings. Choose the best location
depending on the type of grinder.
22/03/2016
PM3115

User manual

10mm, 14mm, 17mm
6mm
6 protection guard
7 clamping lever
8 clamping assembly, clamping part
9 clamping assembly, fixed part
10 base
3
®
© Velleman nv