Quick Start; Charging Battery - Volfoni VPEG-05010 Manuel D'utilisation

4. QUICK START

To watch active displays using your ActivEyes System in
universal infrared 3D mode :
1. Using the connection cable, plug the ActivEyes Pro to
the ActivMe Pro, and place the glasses on your head.
2. Check that the "function" selector on the ActivMe Pro
is on "1".
3. Switch the power on. The glasses should blink once
each eye to signal that the system is up and running.
4. As soon as the IR or RF signal is identified and
interpreted, the glasses go into 3D mode. You can now
attach the ActivMe Pro to the front of your clothing or
attach to the lanyard, making sure that the IR window is
not obscured.
To watch passive displays (for VBAE-01000 models only) :
Simply wear your ActivEyes Pro. There's no need to plug
or power on the ActivMe Pro.

5. CHARGING BATTERY

To charge the ActivMe Pro, plug it in using the Micro-USB
cable to any 5V USB power source (or computer). The
LED should go red until the battery is fully charged, then
the LED goes green, typically after 2.5 hours. The battery
is estimated to last 30 hours before needing a recharge.
Your ActivMe can operate while charging.
6
6. UPDATE YOUR ACTIVEYES PRO
Before using the ActivEyes Pro glasses, make sure you
have the latest version of software from our website.
For this purpose, please download the « Volfoni Loader
» software (http://www.volfoni.com/en/support) and
connect your glasses to your computer. Then start the
software and follow the instructions below.
- choose the menu "SUPPORT"
- choose "Upgradable Software"
- download the application "VOLFONI LOADER"
- connect your computer to the μUSB connector on
ActivMe with the USB/μUSB cable
- press and hold the button of the ActivMe, and switch
ON the ActivMe
- the LED of the ActivMe will light red
- verify that the application recognizes your system
- once you are connected, press the button "Check for
updates"
- download the lastest version
7