LEMAN LOMAX120 Manuel D'utilisation page 18

- Reduce the speed, lift out and stop the machine.
- Clean carefully the paddles after use.
1. Inspecting the tool
Since use of a dull tool will degrade efficiency and cause possible motor malfunction, replace the tool as soon
as abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
For safe and proper working, always keep the machine and ventilation slots clean.
4. Inspecting the carbon brushes (Fig 6 & 7)
The Motor employs carbon brushes which are consumable parts. When they become worn to or near the "wear
limit", it could result in motor trouble. The power tool must then be sent to an after-sales service agent.
When you have to replacement the carbon brushes by yourself, please following the order
(1) Loosen and remove the two brush caps (3) on the motor cover.
(2) Remove the carbon brushes.
(3) After replacing the carbon brushes, reinstall and screw the two brush caps (3).
CAUTION:
Repair, modification and inspection must be must be carried out by a LEMAN Authorized Service Center.
In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country
must be observed.
MODIFICATIONS:
LEMAN Power Tools are constantly being improved and modified to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or design) may be changed without prior notice.
Do not dispose of electric tools together with household waste material!
In observance of European Directive on waste electrical and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
GB
MAINTENANCE AND INSPECTION
DISPOSAL
18
：