Product Description; Designated Use; Restrictions Of Use; Technical Data - erba 18065 Mode D'emploi

GB - INSTRUCTION MANUAL

2. PRODUCT DESCRIPTION

1 - Tool holder
2 - On/Off Switch
3 - Air coupling
4 - Mini-oiler

3. DESIGNATED USE

The die-grinder is designed for grinding, cutting, engraving and general shaping of parts while being
connected to a suitable air compressor. Any other use is prohbited. The buyer accepts all liabilities,
legal and otherwise, for any damage or injury resulting from improper use of the product (i.e. any
other use than the above stated designated use).
4. RESTRICTIONS
Please note, that this product is not designed for commercial or industrial use. We accept no liability
or warranty claims should the product be used in industrial and/or commercial operations.

5. TECHNICAL DATA

Collets:
Working pressure:
Max. RPM:
Air consumption:
Sound pressure level L(pa):
Sound pressure level L(wa):
Vibration on handle:

6. NOISE EMISSION VALUES

See technical data - use of ear protection is recommended.

7. IMPORTANT INFORMATION FOR INITIAL OPERATION

See operation instructions.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
5 - Grinding bits
6 - Collets
7 - Euro connector
8 - Spanners
Page 10
Changes, print, punctuation and other errors reserved!
3 + 6 mm
4 - 6,3 bar
22.000 U/min
130 l/min
91,6dB(A)±3dB
102,6dB(A)±3dB
4,3 m/s
2
Instruction manual
18065
Issue: 10/2017