Operation Instructions; Service And Replacement Parts; Warranty; Disposal - erba 18070 Mode D'emploi

GB - INSTRUCTION MANUAL

8. OPERATION INSTRUCTIONS

Make sure the power regulator (2) is closed before you connect the die grinder to an air compressor.
Always use the mini-oiler that comes with this set to ensure constant oiling of the die grinder.
Put the desired tool in the tool connector and fasten it with a spanner. Make sure the tool is dead
center and does not wobble (use low power at first to check the tool).
The die grinder is now ready for use. To start the die grinder, slowly turn the power regulator. The
further you open the power regulator, the faster the tool will rotate. To stop the grinder, turn the
power regulator all the way back.
Do not use bent or damaged tools!

9. SERVICE AND REPLACEMENT PARTS

Use original spare parts only.

10. WARRANTY

Legal warranty regulations apply.

11. DISPOSAL

Our products are packed in order to prevent damage during transport. Packing materials are va-
luable resurces and therefore can and should be recycled. The product itself consists of various
materials (metals, oils, plastic, etc.) and should be disposed with care and in accordance with your
federal and local disposal regulations.

12. LEGAL INFORMATION

All rights reserved. This manual is copyrighted. Reproduction in and form (digital, print, etc.) is
strictly prohibited without the written permission of ERBA GmbH.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 11
Changes, print, punctuation and other errors reserved!
Instruction manual
18070
Issue: 06/2017